Features 18 gauge
bonded wire; Taillight, stop and turn functions printed on wire;
Ground wire runs full length of assembly; Conforms to SAE
specification J1128
4-Way
Flat Connector
Trailer
End
Part#74124
4-Way
Flat Vehicle End with 60" of Wire
5
way flat wiring
This application is mostly
used for trailers with surge brakes. The fifth wire hook up allows the
trailer brakes to not engage when backing up.
5-Way
Flat Connector - Vehicle End - 6'
Part
Number 85213
5-Way
Flat Connector - Trailer End - 4'
Part
Number 85214
Mates with most std. Flat 4-Way Plugs
Includes 5th circuit for back-up lights, surge brake lockouts, or other low-amp 12V options.
4
way round wiring
This connector is primarily
used for towed vehicles, ie; flat towing vehicles behind motor homes.
This connector incorporates
the use of electric brakes, in addition to lighting.. Used mostly on
horse trailers and lighter equipment.
6-Way
Metal Vehicle End (Requires Mounting Bracket PN 74132)
Part
Number 74129
6-Way
Metal Trailer End
Part
Number 74130
7
way RV STYLE wiring
The most commonly used
connector, when towing a trailer with electric brakes.
7-Way
Plastic Vehicle End (Requires Mounting Bracket PN 74128)
Part Number
74126
7-Way
Plastic Trailer End
Part
Number 74127
7 WAY
TESTER TRAILER EMULATOR
7-WAY TRAILER EMULATOR
7-Way Trailer Emulator is used for the proper installation and set-up of a trailer brake control when a trailer is not readily available. Brake control set-up is accomplished using a built-in load module that will simulate electric magnetic brakes on a trailer. The emulator will also check electrical continuity of all circuits in the 7-Way blade style connector.
$37.00
FLAT
FOUR CIRCUIT TESTER
Pocket size to test Right Turn, Left Turn,
Taillights and Brakes
